unboxing

Congratulations on the purchase of your COMMENCAL RAMONES 14. Here we offer some help so you can build it up and get out there!

1

Prepare the necessary tools before you start:

- 4/5mm Allen key

- 4/5mm Torque wrench

- Flathead screwdriver (for staples)

- Cutting pliers (for plastic cable ties)

- Grease

- 15mm Flat wrench

2

Remove the staples from the box and open it.

3

Take the bike out of the box.

4

Cut the plastic cable ties.

5

Remove all protective coverings.

6

Check accessory box.

7

Identify the black M6 countersunk screw in the accessories box.

8

Remove the screw and the transport headset cap (Allen 5mm).

9

Place the stem/handlebar combo on the fork steerer.

Align with the plastic spacer of the headset.

10

Install the black screw in the stem (Allen 4mm).

11

Tighten the black screw finger-tight to eliminate play in the steering.

12

Align the handlebar with the front wheel, and tighten the lateral stem screw (Allen 5mm).

13

Tighten the lateral stem screw to 6-8N.m (Torque wrench 5mm).

14

Identify the M6 screws, washers and safety spacers for the front hub.

15

Install the screws, washers and safety spacers on the front hub axle.

16

Tighten the hub screws (Allen 5mm).

17

Adjust brake caliper, and tighten caliper screws (Allen 5mm).

18

Tighten the rear wheel axle screws to 6-8N.m (Torque wrench 5mm).

19

Tighten the front wheel axle screws to 6-8N.m (Torque wrench 5mm).

20

Apply grease on pedal axle threads.

21

Install right pedal on right crank arm. Rotate clockwise.

22

Install left pedal on left crank arm. Rotate counterclockwise.

23

Tighten pedal axles to 35N.m.

24

Adjust the saddle height, align it with the frame (Allen 4mm).

25

Tighten the seat clamp screw to 5N.m (Torque wrench 4mm).

26

Note: the transport screw and cap are no longer needed.

Your RAMONES 14 is ready to ride!